An easier way to do this is feed a piece of safety wire from the front through the ring and cable guard towards the rear baggage compartment bulkhead. The rudder cables are hard to feed through the ring in the front of the baggage compartment. Do not feed it into the bulkhead behind the baggage compartment yet.ĥ. Feed the rudder cables through the snap bushings and nylon guide blocks previously installed in the tail cone bulkheads. Starting at the rear of the tailcone feed the threaded end of the rudder cables through the slots just above the lower longeron.Ĥ. Repeat step 1 for the right side using P8911 Right rudder cable fairlead.ģ. Note: NEVER use pliers on the threads, as they will damage the threads.Ģ. To help pull, you can temporarily install the P8607 Eyelet on threaded end to give a better grip. The hole is a tight fit for the threaded end and might take some effort to pull the end through. Slide the threaded end of the P8912 rudder cable through the P8910 Left rudder cable fairlead as shown.
0 kommentar(er)
